6. Align the memory module with the connector on the ServeRAID adapter and
push it into the connector until it is firmly seated.
If you have other devices to install or remove, do so now. Otherwise, go to
“Completing the installation” on page 109.
Installing a RAID adapter battery remotely in the server
When you install any RAID adapter that comes with batteries, it is sometimes
necessary to install the batteries in another location in the server to prevent the
batteries from overheating.
To install a RAID adapter battery in the server, complete the following steps:
1. Read the safety information that begins on page vii and “Installation guidelines”
on page 37.
2. Turn off the server and peripheral devices and disconnect all power cords and
external devices.
3. Remove the cover (see “Removing the left-side cover” on page 60).
4. Install the ServeRAID adapter on the system board (see “Installing an adapter”
on page 86) .
5. Connect one end of the battery cable to the RAID adapter battery connector.
6. Route the remote battery cable as shown in the following illustration.
Chapter 2. Installing optional devices 91
To Next Page
Loading...
