IBM System x3500 - Using the Serverguide Setup and Installation CD

Table 10. Server configuration and applications for configuring and managing RAID arrays
Server configuration
RAID array configuration
(before operating system is
installed)
RAID array management
(after operating system is
installed)
ServeRAID-M1115 adapter MegaRAID BIOS
Configuration Utility (press
Ctrl+H to start), pre-boot CLI
(press Ctrl+P to start),
ServerGuide, HII
MegaRAID Storage Manager
(MSM), MegaCLI (Command
Line Interface), and IBM
Director
ServeRAID-M5110 adapter MegaRAID BIOS
Configuration Utility (press
Ctrl+H to start), pre-boot CLI
(press Ctrl+P to start),
ServerGuide, HII
MegaRAID Storage Manager
(MSM), MegaCLI, and IBM
Director
ServeRAID-M5120 adapter MegaRAID BIOS
Configuration Utility (press
Ctrl+H to start), pre-boot CLI
(press Ctrl+P to start),
ServerGuide, HII
MegaRAID Storage Manager
(MSM), MegaCLI, and IBM
Director
Notes:
1. For more information about the Human Interface Infrastructure (HII) and
SAS2IRCU, go to http://www-947.ibm.com/support/entry/portal/
docdisplay?lndocid=MIGR-5088601.
2. For more information about the MegaRAID, go to http://www-947.ibm.com/
support/entry/portal/docdisplay?lndocid=MIGR-5073015.
Note: Do not install the ServeRAID M5120 SAS/SATA adapter in slot 4, 7, and 8
for proper cooling.
Using the ServerGuide Setup and Installation CD
The ServerGuide Setup and Installation CD provides software setup tools and
installation tools that are designed for your server. The ServerGuide program
detects the server model and hardware options that are installed and uses that
information during setup to configure the hardware. Use this CD during the initial
installation of the server to simplify the operating-system installations by providing
updated device drivers and, in some cases, installing them automatically. To
download the CD, go to http://www.ibm.com/support/entry/portal/
docdisplay?lndocid=SERV-GUIDE and click IBM Service and Support Site.
Note: Changes are made periodically to the IBM website. The actual procedure
might vary slightly from what is described in this document.
To start the ServerGuide Setup and Installation CD, complete the following steps:
1. Insert the CD, and restart the server. If the CD does not start, see “ServerGuide
Problems” in the Problem Determination and Service Guide on the System x
Documentation CD.
2. Follow the instructions on the screen to:
a. Select your language.
b. Select your keyboard layout and country.
c. View the overview to learn about ServerGuide features.
118 IBM System x3500 M4 Type 7383: Installation and User’s Guide