Note: The positioning of the remote battery depends on the type of the
remote batteries that you install.
b. Connect the other end of the battery cable to the battery cable connector on
the battery.
c. Lower and press down on the retention clip until it snaps in place to hold the
battery firmly in place.
If you have other devices to install or remove, do so now. Otherwise, go to
“Completing the installation” on page 109.
Installing the microprocessor 2 expansion board
To install the microprocessor 2 expansion board, complete the following steps:
1. Read the safety information that begins on page vii and “Installation guidelines”
on page 37.
2. Turn off the server and all attached devices; then, disconnect all power cords
and external cables.
3. Carefully turn the server on its side so that it is lying flat, with the cover facing
up.
Attention: Do not allow the server to fall over.
4. Unlock and remove the left-side cover (see “Removing the left-side cover” on
page 60).
5. Remove the fan cage assembly (see “Removing the fan cage assembly” on
page 61).
6. Touch the static-protective package that contains the microprocessor 2
expansion board to any unpainted metal surface on the server; then, remove
the microprocessor 2 expansion board from the package.
7. Install the microprocessor 2 expansion board side bracket.
Chapter 2. Installing optional devices 93
To Next Page
Loading...
