Installing a USB embedded hypervisor flash device
To install a hypervisor flash device, complete the following steps:
1. Read the safety information that begins on page vii and “Installation guidelines”
on page 37.
2. Turn off the server and peripheral devices and disconnect the power cords.
3. Remove the cover (see “Removing the left-side cover” on page 60).
4. Unlock the retention latch by pushing it down toward the system board.
5. Align the flash device with the USB connector on the system board and push it
into the USB connector until it is firmly seated.
6. Return the retention latch to the locked position by pulling it away from the
system board.
If you have other devices to install or remove, do so now. Otherwise, go to
“Completing the installation.”
Completing the installation
To complete the installation, complete the following steps:
1. If you removed the fan cage assembly, reinstall it (see “Replacing the fan cage
assembly” on page 110).
2. If you removed the air baffle, reinstall it (see “Replacing the air baffle” on page
112).
3. If you removed the server cover, replace it (see “Replacing the left-side cover”
on page 113).
Chapter 2. Installing optional devices 109
To Next Page
Loading...
Need help?
General