IBM System x3650 M4 Type 7915 User Manual

end of the upper expansion slot of the riser-card assembly. See “Stretching
a PCI riser-card assembly” on page 59 for instructions.
PCI
riser-card
assembly
Full-length
adapter
bracket
c. Align the adapter with the PCI connector on the riser card and the guide on
the external end of the riser-card assembly.
d. Press the adapter firmly into the PCI connector on the riser card.
PCI
riser-card
assembly
(in long position)
Adapter
Adapter
connectors
PCI
riser-card
assembly
(in short position)
Adapter
Adapter
connectors
Full-length
adapter
bracket
Full-length
adapter
bracket
9. Connect any required cables to the adapter.
Attention:
v When you route cables, do not block any connectors or the ventilated space
around any of the fans.
v Make sure that cables are not routed on top of components that are under
the PCI riser-card assembly.
v Make sure that cables are not pinched by the server components.
10. Align the PCI riser-card assembly with the selected PCI riser-card connector
on the system board.
62 System x3650 M4 Type 7915: Installation and User’s Guide

IBM System x3650 M4 Type 7915 Specifications

General

Form Factor	2U Rack
Chipset	Intel C600 series chipset
Operating System Support	Microsoft Windows Server, Red Hat Enterprise Linux, SUSE Linux Enterprise Server, VMware vSphere
Processor	Up to two Intel Xeon E5-2600 series processors
Memory	Up to 768GB DDR3 (24 DIMM slots)
Storage	Up to 16 x 2.5" or 6 x 3.5" SAS/SATA HDDs or SSDs
RAID Support	RAID 0, 1, 10
Network	Four integrated Gigabit Ethernet ports
Power Supply	Up to two redundant hot-swap 550 W, 750 W, or 900 W power supplies
Expansion Slots	Up to 7 PCIe 3.0 slots
Storage Controller	ServeRAID M5110e
Management	Integrated Management Module (IMM) v2