IBM x3200 M3 7327 User Manual

5. Install the eight screws (seven in front and one in rear) that secure the system
board to the chassis.
6. Install any of the following components that you removed from the system
board:
v The fan connector covers.
v Hypervisor key (see “Installing a USB embedded hypervisor flash device” on
page 180).
v Virtual media key (see “Installing the virtual media key” on page 182).
v SAS/SATA controller (see “Installing a ServeRAID-BR10il v2 SAS/SATA
controller” on page 205 ).
v Battery (see “Installing the battery” on page 184).
v DIMMs (see “Installing a memory module” on page 169).
v Microprocessor and fan sink (see “Installing a microprocessor and fan sink”
on page 211).
v Adapters (see “Installing an adapter” on page 152).
7. Press and hold the retaining tab on top of the cage; then, rotate the drive cage
into the chassis until it locks into place.
8. Reconnect any cables to the system board that you disconnected during
removal.
9. Install the side cover (see “Installing the side cover” on page 146).
10. Lock the side cover if you unlocked it during removal.
11. Reconnect the external cables and power cords; then, turn on the attached
devices and turn on the server.
Chapter 5. Removing and replacing server components 219

IBM x3200 M3 7327 Specifications

General

Form Factor	Tower
Processor Sockets	1
Chipset	Intel 3420
Memory	Up to 32 GB
Memory Slots	4
Storage	Up to 8 TB
Hard Drive Bays	4
Processor	Intel Xeon 3400 series
Memory Type	DDR3
RAID Support	RAID 0, 1, 10
Network	Dual Gigabit Ethernet
Expansion Slots	4
Operating System Support	Windows Server, Red Hat Enterprise Linux, SUSE Linux Enterprise Server
Drive Bays	4 total (3.5-inch)