7. Reconnect the power cord and any cables that you removed.
8. Install and lock the side cover (see “Installing the side cover” on page 146).
9. Reconnect the power cord and any cables that you removed.
10. Turn on the peripheral devices and the server.
Removing the virtual media key
To remove the virtual media key, complete the following steps:
1. Read the safety information that begins on page vii and “Installation guidelines”
on page 141.
2. Turn off the server and peripheral devices and disconnect all power cords; then,
remove the side cover (see “Removing the side cover” on page 145).
3. Grasp the virtual media key and gently slide it up and off of the mounting tab.
Chapter 5. Removing and replacing server components 181
To Next Page
Loading...
