Torus 126, 380 and 500 Operator Manual
Rev AB Safety Warnings for 126, 380 and 500 Printers 2-7
Safety Warnings for 126, 380 and 500 Printers
Some additional warnings that are specific to the 126, 380 and 500 printers
are described in this section.
Before opening or removing any printer covers, ensure that the
mains power is disconnected and compressed air supplies are
switched off.
This equipment must be installed with a locally positioned mains
supply isolation device. This can be either a plug and socket or a
switch disconnector or circuit breaker in accordance with IEC 60947-
3 or IEC 60947-2.
Always isolate equipment from the mains and remove mains power
connector to the printer before attempting any maintenance or repair
on any part of the product.
Before connecting compressed air supply to Torus 126, 380 and 500,
ensure the air regulator adjustment knob has been turned fully anti-
clockwise.
Ensure that any cables from the printer are secured to avoid chance
of movement into walkways and becoming a trip hazard.
To Next Page
Loading...
Need help?
General
