Ice Torus 126 User Manual

Torus 126, 380 and 500 Operator Manual
4-2 Turn on the Printer
Rev AB
The sequence of steps that occur after you turn on the printer are as
follows:
1 During the startup sequence, the printer performs a number of self-
diagnostic checks. These checks take approximately 90 seconds to
complete.
2 During the self-diagnostic checks, the CLARiTY™ interface screen
shows the first set of diagnostic data. Ignore this data.
3 When the self-diagnostic checks are complete, the CLARiTY™ Home
Page appears (refer to
Figure 4-2).
4 The status window of the Home Page shows the SHUTDOWN status.
5 During the SHUTDOWN status, the Stop (red) and Run (green)
buttons (
Figure 4-2) are disabled (in grey color).
Note: If the print sensor is activated accidentally, the printer will not operate
because all the sensor and encoder input are ignored during the shutdown
status.
Note: During the shutdown status, make sure that the production line and
printer are prepared and ready for the shutdown.
Figure 4-2: Home Page
Stop(red)
Run(green)
Shutdown
Shutdown Status

Ice Torus 126 Specifications

General

Brand	Ice
Model	Torus 126
Category	Printer
Language	English