Icom IC-A15 - Copying Memory Contents

16
4
MEMORY OPERATION
NOTE: When entering a memory name to the memory
channel, follow these steps.
q Select the memory channel you want to name. (see p.
12).
For the IC-A15
w Push [FUNC], then push [MW](MR).
• The selected memory contents copied into frequency mode and
frequency mode is selected automatically.
e Push [FUNC], then push [MW](MR) again.
r Push [MR] momentarily to select memory name entry
mode.
t Perform the steps t and y described on page 15 in “For
the IC-A15” to enter the memory name.
For the IC-A15S
w Hold down [MR] for 1 second.
• The selected memory contents copied into frequency mode and
frequency mode is selected automatically.
e Hold down [MR] for 1 second again.
r Push [MR] momentarily to select memory name entry
mode.
t Perform the steps t and y described on page 15 in “For
the IC-A15S” to enter the memory name.
■ Copying memory contents
This function copies a memory channel’s contents into the
frequency mode. This is useful when searching for signals
around a memory channel’s frequency.
q Push [MR] to select memory mode.
w Select the memory channel to be copied using [Y]/[Z]
(or
keypad and [ENT], For the IC-A15 only).
• Select the bank.
For the IC-A15
e Push [FUNC], then push [MW](MR) to copy the memory
channel’s contents into the frequency mode.
• The frequency mode is automatically selected.
For the IC-A15S
e Hold down [MR] for 1 second to copy the memory chan-
nel’s contents into the frequency mode.
• The frequency mode is automatically selected.
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19