Icom IC-A15

34
10
SPECIFICATIONS
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
D General
• Frequency coverage: 118.000 to 136.975 MHz
• Mode: 6K00A3E
• Channel spacing: 25 kHz
• Number of memory channels:
IC-A15 200 (20 CH × 10 BANKS)
IC-A15S 100
• Power supply requirement: Specified Icom’s battery packs
7.4 V DC standard
• Usable temperature range: –20˚C to +55˚C
• Current drain (at 7.4 V DC):
Tx 1.5 A
Rx at stand by 50 mA typical
at AF max. 500 mA
• Antenna connector: BNC 50 Ω (nominal)
• Dimensions: 53 (W) × 120 (H) × 36.9 (D) mm
(projections not included)
• Weight: Approximately 180 g
(Without the battery pack and antenna.)
D Transmitter
• Output power : 5.0 W (PEP) typical
1.5 W (CW)
• Modulation: Low level modulation
• Modulation depth: 85%
• Frequency stability: ±5 ppm
• Audio harmonic distortion: Less than 10% (at 85%+3 dB modula-
tion)
• Harmonic spurious emissions: Less than –36 dBm (except operating
frequency ±1 MHz range)
• External MIC connector: 3-conductor 2.5(d) mm (
1
⁄10˝)/
150 Ω
D Receiver
• Receive system: Double conversion superheterodyne
• Intermediate frequencies: 1st 46.35 MHz, 2nd 450 kHz
• Sensitivity (12 dB SINAD): –3 dBµ typical
• Squelch sensitivity (threshold): Less than 0 dBµ
• Selectivity : 6 dB (More than 7.5 kHz)
60 dB (Less than 25 kHz)
• Spurious response rejection: More than 70 dB
• Audio output power: More than 700 mW (internal SP)
( at 10% distortion into an 8 Ω More than 500 mW (external SP)
load, 30% modulation)
• Hum and noise: More than 40 dB at 90% mod.
• External SP connector: 3-conductor 3.5 (d) mm (
1
⁄8˝)/8 Ω
All stated specifications are subject to change without notice or obligation.