20
6
7
8
9
10
11
12
13
14
15
16
17
18
19
1
2
3
4
5
5
REPEATER OPERATION
■ Subaudible tone encoder
Some repeaters require subaudible tones to be accessed.
Subaudible tones are superimposed over your transmitted
signal and must be set first.
q Push [FUNC](M) then [SET](8) to enter the Set mode.
w Push [] or [] to select the Repeater tone encoder item.
(rt)
e Rotate [VOL] to select the subaudible tone.
r Push [# ENT](MN.W) to exit the Set mode.
• Available subaudible tone frequencies (unit: Hz)
D Tone information
Some repeaters require a different tone system to be ac-
cessed.
DTMF TONES
While pushing [PTT], push the desired DTMF keys, [0] to [9],
[MONI](A), [](B), [](C), [
](D), [M](E), or [# ENT](F),
to transmit their assigned DTMF codes.
• The transceiver has 16 DTMF memory channels (p. 27).
DTCS CODES
Push [FUNC](*), and then [TONE](1) one or more times to
activate the DTCS encoder, and then push [PTT].
• “
” and “ ” appear.
• The specied DTCS code is superimposed over your transmitted
signal.
• See page 24 for DTCS code setting details.
✔ CONVENIENT!
Tone scan function:
If you don’t know the subaudible tone or DTCS code used for
a repeater, the tone scan is convenient for detecting it.
➥ Push [FUNC](M), and then [T.SCAN](3) to start a tone
scan.
• When the required tone frequency or DTCS code is detected, the
scan pauses, and it is temporarily set.
• See page 26 for Tone Scan function details.
88.5 Hz repeater tone
[VOL]
67.0
69.3
71.9
74.4
77.0
79.7
82.5
85.4
88.5
91.5
94.8
97.4
100.0
103.5
107.2
110.9
114.8
118.8
123.0
127.3
131.8
136.5
141.3
146.2
151.4
156.7
159.8
162.2
165.5
167.9
171.3
173.8
177.3
179.9
183.5
186.2
189.9
192.8
196.6
199.5
203.5
206.5
210.7
218.1
225.7
229.1
233.6
241.8
250.3
254.1
To Next Page
Loading...
