9
SET MODES
D Microphone gain
Sets the microphone gain to between 1 and 4 to suit your
needs. Higher values make the microphone more sensitive
to your voice.
NOTE: When using the VOX function, we recommend set-
ting the microphone gain to 3. However, you can adjust it
to suit your operating environment (including your headset
performance).
D VOX delay
The VOX Delay is the amount of time the transmitter stays
ON after you stop speaking.
Sets the VOX Delay to between “VXd.05” (0.5 seconds) ,
“VXd.10” (1 second), “VXd.15” (1.5 seconds), “VXd.20”
(2 seconds), “VXd.25” (2.5 seconds) and “VXd.30” (3 seconds).
D VOX Time-out Timer
Sets the VOX Time-out Timer to 1, 2, 3, 4, 5, 10 or 15 min-
utes to prevent accidental prolonged transmission by the VOX
function.
To turn OFF the function, select “Vto.OF.”
The VOX Time-out Timer must be set shorter than the
Time-out Timer, otherwise this timer will not function.
D DTMF TX key
Selects the method to transmit a DTMF code sequence.
While holding down [PTT], push one of the keys, [0] to [9],
[MONI](A), [](B), [](C), [
](D), [M](E), and [# ENT]
(MN.W)(F).
• dmt.k : Transmits the appropriate DTMF code assigned to the
key.
• dmt.m :
Transmits the programmed DTMF code sequence in the
DTMF memory channel assigned to the key.
D Operating mode
Set the operating mode to FM or FM-N. The operat-
ing mode is determined by the modulation of the radio
signal.
To Next Page
Loading...
