30
9
10
9
SET MODES
■ Set mode programming
The Set mode is used to change the settings of the trans-
ceiver
’s functions.
D Set mode operation
q
Push [FUNC](M), and then [SET](8) to enter the Set mode.
w Push [] or [] to select the item.
e Rotate [VOL] to select the option or value.
r To exit the Set mode, push [# ENT](MN.W).
1
2
4
3
5
6
7
8
11
12
14
13
15
16
17
18
19
• Repeater tone
frequency (p. 31)
• Tone squelch
frequency (p. 31)
• DTCS code (p. 31) • DTCS polarity (p. 31)
•
Scan resume setting (p. 32)
•
Function key timer (p.
32
)
• VOX gain (p.
32
)
• Microphone gain (p. 33)
• VOX delay (p.
33
)
•
VOX time-out timer(p. 33)
• DTMF TX key (p.
33
)
: Push
: Push
• Operating mode (p. 33)
•
LCD backlight (p.
32
)
To Next Page
Loading...
