21
5
REPEATER OPERATION
■ Lockout function
The Lockout function helps prevent interference to other sta-
tions by inhibiting transmitting when the channel is busy.
The function is set in the Initial Set mode.
q While holding down [] and [], turn ON the power to
enter the Initial Set mode.
w Push [] or [] to select the lockout item. (RLO)
e Rotate [VOL] to select an option of the Lockout function.
• “RLO.OF” : Allows transmitting, even if the channel is busy.
• “RLO.RP” : The Repeater Lockout function inhibits transmitting
when the channel is busy, except while receiving a
signal that includes a matching subaudible tone.
• “RLO.bU” : The Busy Lockout function inhibits transmitting
when the channel is busy.
r Push [# ENT](MN.W) to exit the Initial Set mode.
The Repeater Lockout
function is ON.
[VOL]
To Next Page
Loading...
