7
TONE SQUELCH AND POCKET BEEP
■ Tone/DTCS squelch and pocket beep (Continued)
D
Setting DTCS polarity
For DTCS operation, the polarity setting is configurable, as
well as the code setting. If the polarity is different, the DTCS
squelch never opens, even when receiving a signal that in-
cludes a matching DTCS code.
q Push [FUNC](M), and then [SET](8) to enter the Set mode.
w Push [] or [] to select the DTCS polarity item (dtP).
e Rotate [VOL] to select a polarity setting between “dtP.nn”
(TX and RX normal), “dtP.nR” (TX: normal, RX: reverse), “dtP.
Rn”
(TX: reverse, RX: normal) and “dtP.RR” (TX and RX re-
verse).
r Push [# ENT](MN.W) to exit the Set mode.
NOTE: When you use the DTCS encoder, the DTCS po-
larity setting affects only transmitting.
D
Operation
q Select an operating channel (p. 15), and then set a CTCSS
tone or a DTCS code (p. 24).
w Push
[FUNC](M), and then [TONE](1).
• Repeat step w one or more times to activate the desired Tone function.
e Operate the transceiver in a normal way. (p. 15)
NOTE: The Tone function is automatically returned to the
setting pre-programmed by your dealer, if you change the
operating channel.
TX and RX: Normal polarity TX: Normal, RX: Reverse
TX: Reverse, RX: Normal TX/RX: Reverse polarity
Function OFF
: Push , and then .
Tone squelch with
pocket beep
Tone squelch
DTCS squelch
DTCS squelch with pocket beep
Repeater tone encoder
DTCS encoder
To Next Page
Loading...
