Icom IC-M220

3
1
7
4
10
15
18
2
8
13
5
11
16
3
9
14
6
12
17
PANEL DESCRIPTION
2
■ Function Display
1STATUS INDICATOR (p. 10)
• TX: Displayed while transmitting.
• BUSY: Displayed while receiving, or
the squelch is open.
2POWER INDICATOR (p. 5)
• 25W: High power
• 1W: Low power
3CHANNEL GROUP INDICATOR
(pp.7~8)
Displays the selected channel group, INT
(International), USA, CAN (Canada), WX
(Weather channel).
L The selectable channels differ,
depending on the version or presetting.
L When the WX-Alert is set to ON, “
” is
displayed. (For only the USA version)
4STATUS INDICATOR
• STBY: Standby mode.
• RT: Displayed when the channel
is changed while receiving or
transmitting a signal.
5GPS ICON
• Displayed when valid GPS position
data is received.
• Blinks while no position data is
received.
6MAIL ICON (p. 33)
• Displayed when there is an unread
DSC message.
• Blinks until one of the called messages
is read.
7CHANNEL SWITCH ICON (p. 36)
Displayed when the “CH Auto SW” is set to
“Ignore after 10 sec.” or “Manual.”
8LOCAL INDICATOR
Displayed when the RF Attenuation is ON.
(For only the USA version)
9FAVORITE CHANNEL (p. 13)
Displayed when a Favorite channel is
selected.
CALL CHANNEL (p. 10)
Displayed when a Call channel is selected.
DUPLEX CHANNEL
Displayed when a Duplex channel is
selected.
OPERATING CHANNEL NUMBER
(pp. 7, 11)
Displays the selected operating channel
number.
L “A” or “B” is displayed when a simplex
channel is selected.
SOFTWARE KEYS FUNCTION
DISPLAY (p. 4 ~ 5)
The functions of each keys are
displayed. See “Software keys” on the
next page for details.
(☞Continued on the next page)
1 2 3 4 5 6 7 8
9





