Icom IC-M220 - Aquaquake Water Draining Function; Editing a Channel Name

11
1
7
4
10
15
18
2
8
13
5
11
16
3
9
14
6
12
17
BASIC OPERATION
4
■ AquaQuake Water Draining function
Water in the speaker grill may mufe the sound coming from the speaker. The
AquaQuake Water Draining function removes water from the speaker grill by vibrating the
speaker cone.
CAUTION: DO NOT use the AquaQuake Water Draining function when an external
speaker is connected.
1. Push [◄] or [►] to display
AQUA
.
2. Hold down
AQUA
to turn ON the function.
• A low frequency vibration beep sounds to drain the
water, regardless of the volume level setting.
L This function is activated for a maximum of 10
seconds, even if you continue to hold down
AQUA
.
3. Release the key to turn OFF the function.
■ Editing a channel name
You can edit the name of each operating channel and weather channel, using numbers,
uppercase letters, symbols, and a space. This enables easy recognition of the channels
or stations. All VHF marine channels are set with default names.
L You can edit channel names only when the “CH Close-up” is set to ON.
[MENU] > Radio Settings > CH Close-up
1. Push [▲] or [▼] to select the channel to edit.
2. Push [◄] or [►] to display
NAME
.
L You cannot edit a channel name during Dualwatch,
Tri-watch, or a scan.
3. Push
NAME
.
• The “CHANNEL NAME” screen is displayed.
4. Edit the channel name.
5. Push
FIN
to save the edited name and return to the
operating screen.
TIP:
• Push
123
to display numbers, or
!$?
to display characters.
• Select characters or space using [▲]/[▼]/[◄]/[►].
• Select “◄” or “►” on the screen to scroll.
• Push [ENT] to enter the selected character.
• Select “←” or “→” on the screen to move the cursor.