18
5
MEMORY OPERATION
5
■ Programming channel names
Each memory channel can be programmed with an alphanu-
meric channel name for easy recognition and can be indi-
cated independently by channel. Names can be a maximum
of 6 characters— see the table below for available charac-
ters.
qSelect the desired memory channel to be programmed.
➥ Push [MR•SKIP] to select memory mode
, then rotate
[DIAL] to select the desired memory channel.
wPush [S.MW•MW] to enter select memory write mode
.
•“!” indicator and the memory channel number blink.
e Push [TS•MODE] twice to select the memory name pro-
gramming condition, “m nAmE.”
• Frequency readouts disappear and a cursor blinks.
r Rotate [DIAL] to select the desired character.
• The selected character blinks.
t Push [SET•LOCK] to move the cursor to the right.
• Repeat pushing [SET•LOCK] to return to the first digit.
y Repeat steps r and t until the desired channel names
are displayed.
u Push and hold [S.MW•MW] for 1 sec. to program the
name and exit select memory write mode
.
Push for 1 sec.Repeat the
steps.
memory channel.
To Next Page
