Icom IC-R1500 - SCAN OPERATION; Skip Scan; Skip Channel;Frequency Setting; Skip Scan Function Setting

28
6
SCAN OPERATION
6
■ Skip scan
D Skip channel/frequency setting
You can set the selected memory channel as a skip channel
which is skipped during memory skip scan. In addition, it can
be set as a skip channel for both memory skip scan and fre-
quency skip scan. These are useful to speed up the scan in-
terval.
qSelect a memory channel.
➥ Push [MR•SKIP] to select memory mode
, then rotate
[DIAL] to select the desired memory channel to be a
skip channel.
•“!” and memory channel number appear.
wPush and hold [MR•SKIP] for 1 sec. several times to set
the skip condition.
• (no indication) : The channel is scanned during scan.
• ~ : The channel is skipped during scan.
•
P
~ : The channel is skipped during scan and the pro-
grammed frequency is skipped during VFO scan,
such as programmed scan.
D Skip scan setting [
q Push [SET•LOCK] to enter set mode.
w Push [SET•LOCK] or [S.MW•MW] several times until
“PSC” appears.
e Rotate [DIAL] to toggle the skip scan function ON and
OFF.
r Push [TS•MODE] or any switch below the display to exit
set mode
.
t Then start the scan to activate the skip scan (memory skip
scan or frequency skip scan).
[DIAL]
[S.MW•MW]
[SET•LOCK]
[TS•MODE]
The display shows that
memory channel 16 is
set as a skip channel.
[MR•SKIP]