31
POCKET BEEP AND TONE SQUELCH
8
■ Pocket beep operation
This function uses subaudible tones for calling and can be
used as a “common pager” to inform you that someone has
called while you were away from the receiver.
D Waiting for a call from a specific station
q Set the operating frequency in FM mode.
w Push [SET•LOCK] to enter set mode
.
e Push [SET•LOCK] or [S.MW•MW] several times until “Ct”
(when selecting the tone squelch frequency) or “Dt” (when
selecting the DTCS code squelch) appears.
r Rotate [DIAL] to select the desired tone frequency or
DTCS code.
t When operating the pocket beep function with DTCS code
squelch, push [SET•LOCK] once then rotate [DIAL] to se-
lect the DTCS polarity.
y Push [TS•MODE] or any switch below the display to exit
set mode
.
u Push and hold [MONI•T/T-SCAN] for 1 sec to enter tone
squelch selection mode, then rotate [DIAL] until “S ”
or “ S” appears to turn the pocket beep function ON
with tone squelch or DTCS squelch, respectively.
with tone squelch is turend ON.
with DTCS squelch is turned ON.
To Next Page
Loading...
