E
ach memory channel can be programmed with an alphanu-
meric channel name for easy recognition and can be indicated
independently by channel. Names can be a maximum of 6
characters— see the table on next page for available charac-
ters.
qSelect the desired memory channel to be programmed.
➥ Push [VFO/MR•S.MW] to select memory mode
, then ro-
tate the same band’s [DIAL] to select the desired mem-
ory channel.
wPush and hold [VFO/MR•S.MW] for 1 sec. to enter select
memory write mode.
•“!” indicator and the memory channel number blink.
e Push [SET•SKIP] several times to select the memory
name programming condition, “m nAmE.”
• Frequency readouts disappear and a cursor blinks.
r Rotate the same band’s [DIAL] to select the desired char-
acter.
• The selected character blinks.
t Push [ATT•PRIO] to move the cursor to the right.
• Repeat pushing [ATT•PRIO] to return to the first digit.
y Repeat steps r and t until the desired channel name is
displayed.
u Push and hold [VFO/MR•S.MW] for 1 sec. to program the
name and exit select memory write mode
.
■ Programming channel names
To Next Page
Loading...
