39
POCKET BEEP AND TONE SQUELCH
8
This function uses subaudible tones for calling and can be
used as a “common pager” to inform you that someone has
called while you were away from the receiver.
D Waiting for a call from a specific station
q Set the operating frequency in FM mode.
w Push
[SET•
SKIP
]
to enter set mode in the main band.
e Push
[SET•
SKIP
]
or [ATT•PRIO] several times until “Ct”
(when selecting the tone squelch) or “dt”(when selecting
the DTCS squelch) appears.
r Rotate the main band’s [DIAL] to select the desired tone
frequency or DTCS code.
t When operating the pocket beep function with DTCS code
squelch, push
[SET•SKIP] once then r
otate the main
band’s [DIAL] to select the DTCS polarity.
y Push any key for the main band to exit set mode
.
u Push and hold [MONI•T/T-SCAN] for 1 sec. to enter tone
squelch selection mode, then rotate the main band’s
[DIAL] until “S ” or “ S” appears to turn the
pocket beep function ON with tone squelch or DTCS
squelch, respectively.
with tone squelch is turned ON.
with DTCS squelch is turned ON.
To Next Page
Loading...
