46
9
DIGITAL MODE OPERATION
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
r Rotate the left band’s [DIAL] to select the desired call sign
or code.
• Push [MODE•SCAN] (or [MONI•T/T-SCAN]) to move the cursor.
t Push any key for the main band to exit set mode.
y Push and hold [MONI•T/T-SCAN] for 1 sec. to enter tone
squelch selection mode, then rotate left band’s [DIAL] until
“” or “ ” appears in the function display.
u When a signal with the matched code/call sign is received,
the squelch opens and the receiver emits audio.
• When the received signal includes an unmatched code /call sign,
the squelch does not open. However, the S-meter indicator
shows the received signal strength.
•To open the squelch manually, push [MONI•T/T-SCAN].
i To cancel the digital squelch function, repeat steps e until
“OFF” appears, then push any key.
To Next Page
Loading...
