3
SCAN OPERATION
3-3
About Scans
D [DIAL] operation during a scan
z Rotate [DIAL] to change the scan direction during a
scan.
z Rotate [DIAL] to resume the scan when the scan is
paused.
D Squelch setting for a scan
You can change the squelch level to suit your
operating needs. Set the squelch level to open the
squelch, according to the received signal strength.
L Rotate [DIAL] while holding down [MONI] to adjust the
squelch level during a scan. The scan resumes after
releasing [MONI].
D Tuning step for a VFO scan
The tuning step selected in the Set mode (p. 5-4) is
applied to the scan.
D Scan Skip function
The skip function speeds up scanning by not scanning
those frequencies set as skip channels (p. 3-5).
In the VFO mode:
Skips the frequency assigned as “ ” (p. 3-5).
In the Memory mode:
Skips the memory channel assigned as “ ” or
“ ” (p. 3-5).
TIP: Turn OFF the Program Skip function in the Set
mode (p. 5-4) to execute a scan, including the
skipped frequency.
D Operating mode during a scan
• The VFO scan uses the selected operating mode.
• During a Memory mode scan, the operating mode
entered into the channel is used.
D When a signal is received
When a signal is received, the scan pauses for the
period of time that is set in the Set mode. (p. 5-4)
When a received signal disappears, the scan resumes
after the set period of time.
To Next Page
Loading...
