3
SCAN OPERATION
3-5
Memory Scan
Setting/clearing a Skip Channel
The channels set as Skip channels are skipped during
a scan.
D Setting/clearing a Skip channel
1. Repeatedly push [V/M/C] to select the Memory
mode.
2. Push [S.MW] until two short beeps sound.
• “ ” and the channel number blink.
3. Rotate [DIAL] to select a channel to skip, or a
channel to set or clear.
4. Push [SET].
L “SkIP” is displayed.
L Push [MONI] or [P] to display “SkIP,” if it is not
displayed.
5. Rotate [DIAL] to select an option.
• SkIP: Skips the selected memory channel.
• PSkIP: Skips the selected memory channel in
the Memory mode, and skips the same
frequency in a VFO scan.
• OFF: Scans the selected memory channel.
6. Push [S.MW].
• “ ” and the channel number blink.
7. Push [S.MW] to return to the Memory mode.
Enter two or more memory channels to run the
Memory Scan (p. 2-3).
1. Repeatedly push [V/M/C] to select the Memory
mode.
2. Hold down [SCAN] until a beep sounds to start
the scan.
L While scanning, repeatedly push [SET] to select a
scan type.
Full scan
Band scan
L While scanning, the scan type in progress is
indicated by two letters.
L While scanning, push [BAND] to change the band to
scan, or scope of the Program Scan.
L While receiving a signal, the S-meter displays the
received signal strength.
3. Push [SCAN] or [V/M/C] to cancel the scan.
TIP:
• While scanning, rotate [DIAL] to change the scanning
direction.
• While scanning, hold down [
] to turn the Lock
function ON or OFF.
D Memory Scan type
There are the following types of Memory scans.
L While scanning, the transceiver indicates the
currently selected scan type.
ALL: Full scan
bAnd: Band scan
To Next Page
Loading...
