3
SCAN OPERATION
3-4
VFO Scan
The VFO scan searches for signals within the
1. Repeatedly push [V/M/C] to select the VFO mode.
2. Hold down [SCAN] until a beep sounds to start
the scan.
L While scanning, repeatedly push [SET] to select a
scan type.
Full scan
Band scan
Program scan
L While scanning, the scan type in progress is
indicated by two letters.
L While scanning, push [BAND] to change the band to
scan, or scope of the Program Scan.
L While receiving a signal, the S-meter displays the
received signal strength.
3. Push [SCAN] or [V/M/C] to cancel the scan.
TIP:
• While scanning, rotate [DIAL] to change the
scanning direction.
• While scanning, hold down [ ] to turn the Lock
function ON or OFF.
D VFO Scan type
There are the following types of VFO scans.
ALL: Full scan
bAnd: Band scan
PROG1 ~ 3: Program scan
TIP: About the Band scan
While scanning the VHF or UHF band, push [BAND] to
switch the scan to the other band.
L While scanning the FM radio band, you cannot switch to
VHF or UHF.
D Using the Program Skip function
You can skip unnecessary frequencies during a scan.
Enter the Skip Channel in Memory mode to use the
function.
L The skipped frequencies will be scanned if the Program
Skip function is turned OFF in the Set mode (p. 5-4).
To Next Page
Loading...
Need help?
General
