Icom IC-T10 - Using the DTMF Memory

6
OTHER FUNCTIONS
6-2
Using the DTMF memory
The transceiver can save up to 16 memories of a 24
digit DTMF code.
D Entering the DTMF code
1. Push [SET] to enter the Set mode.
• A Set mode item is displayed.
2. Repeatedly push [SET] to select “dtmF.”
• A DTMF memory channel number blinks.
3. Rotate [DIAL] to select a DTMF memory channel.
4. Hold down [SET] until two beeps sound.
• 
DTMF code Entry mode.
5. Enter the DTMF code using the Ten-keypad.
L Push [MONI] to move the cursor to the right.
L Push [P] to move the cursor to the left.
L The following 6 empty digits are displayed when you
have entered the 6th digit.
L Up to 24 digits of code can be entered.
6. Push [PTT] to confirm the entry.
• The DTMF memory channel number blinks.
7. Push [V/M/C] to exit the Set mode.
D Monitoring the entered DTMF code
You can check and hear the entered DTMF code.
1. Push [SET] to enter the Set mode.
• A Set mode item is displayed.
2. Repeatedly push [SET] to select “dtmF.”
• A DTMF memory channel number blinks.
3. Rotate [DIAL] to select a DTMF memory channel
to monitor.
4. Push [HOME] to exit the Set mode and start
monitoring.
[HOME]
D Clearing the DTMF memory contents

as shown below.
1. Push [SET] to enter the Set mode.
• A Set mode item is displayed.
2. Repeatedly push [SET] to select “dtmF.”
• A DTMF memory channel number blinks.
3. Rotate [DIAL] to select a DTMF memory channel.
4. Hold down [SET] until two beeps sound.
• 
channel content will be deleted.
5. Push [PTT].
• The DTMF memory channel number blinks.
6. Push [V/M/C] to exit the Set mode.