12
4
BASIC OPERATION
■ Dial select function
Use the dial select function to adjust the tuning behaviour or
the [
Y]/[Z] keys—use 1 MHz tuning when you want to
change the frequency in large increments; use the selected
tuning step when you want to change the frequency in smaller
increments.
➀ Push [t] one or more times to
select the desired [
Y]/[Z] key
tuning increment.
• 1 MHz tuning, 100 kHz tuning or
regular tuning steps can be selected
(see diagram at right).
➁ Release [t] to return to normal operation.
■ Receive and transmit
➀ Rotate [PWR/VOL] clockwise to turn power ON.
➁ Adjust volume to the desired level.
• While pushing [ ], rotate [VOL].
➂ Set a frequency.
When a signal is received:
➥ Squelch opens and audio is emitted from the speaker.
➥ “BUSY” appears and the S/RF indicator shows the relative sig-
nal strength.
➃ Push [H/L] to toggle output power between high and low.
•“LOW” appears when low output power is selected.
➄ Push and hold [PTT] to transmit; then speak into the mi-
crophone.
• Do not hold the microphone too close to your mouth or speak
too loudly. This may distort the signal.
• The TX indicator lights red.
• The S/RF indicator shows the output power selection.
To Next Page
Loading...
