28
OTHER FUNCTIONS
■ Initial set mode
Initial set mode is accessed at power on and allows you to
set seldom-changed settings. In this way you can “customize”
transceiver operations to suit your preferences and operating
style.
D Entering initial set mode
➀ While pushing [8] + [0], rotate [PWR] to turn power on.
• The transceiver enters initial set mode and “mS SImP” or “mS
noRm” (see right) is displayed.
➁ Push [t] one or more times to select the desired display
as described on the following pages.
➂ Push [Y]/[Z] to select the desired condition.
➃ Turn power off, then on again to exit initial set mode and
select the previous operating mode.
D Message
When no operation is performed for 5 sec. in initial set mode,
a message scrolls across the function display prompting you
for input.
Q Message example
for microphone simple mode
AT
POWER ON
D Mic simple mode (Optional HM-75A required)
This item turns the microphone simple
mode on or off. Microphone simple
mode is used to change the function
assignments for switches on the op-
tional HM-75A
REMOTE CONTROL MI
-
CROPHONE
as below. This assignment
is convenient for 3-channel use of
simple operation.
*Functions only when in conversation mode.
NOTE:
Turn power off when connecting the HM-75A to the trans-
ceiver.
VFO mode cannot be selected via the microphone when
SIMPLE mode is selected.
NORMAL SIMPLE
Freq. CH
ANI
Freq. CH
ANI
HM-75A
indication indication indication indication
SWITCH
[CALL] NULL NULL [ ] [ ] [ ]*
[V/m] NULL NULL [CALL] NULL NULL
[UP] [UP] [UP] MCH01 MCH01 MCH01
[DOWN] [DOWN] [DOWN]
MCH02 MCH02 MCH02
To Next Page
Loading...
