Icom IC-T2H - Voltage Distribution Diagram

20
6
MEMORY/CALL PROGRAMMING
■ Programming the
call channel
➀ Push [
f
(CALL)] to select call
channel mode.
•“C” appears.
➁ Push [
f
(CALL)] for 1 sec. to enter
set mode.
➂ Push [t] one or more times until
“FR” appears.
➃ Push [6] digit keys to input the de-
sired frequency.
➄ If desired, push [t] again, then
push [
Y]/[Z] to select another item
(e.g. tone setting) and condition.
➅ Repeat step ➄ until all desired in-
formation is programmed into the
call channel.
➆ Push [
f
(CALL)] to exit call channel set mode.
➇ Push [B M].
➈ Push [
f
(CALL)].
➉ Push [B M] for 1 sec.
USING
SET MODE
DUP T
IC-T2H Manual 01.12.5 4:31 PM Page 20 (1,1)