34
11 ANI OPERATION
■ Operation
D Calling a specific station
➀ Turn power on and set the [VOL] control to the 10 or 12 o’-
clock position.
➁ Push the [Y]/[Z] keys to set the desired channel.
•“ ” appears when the ANI function has been programmed via
cloning.
➂ Push [PTT] once to connect to the selected station or enter
a 3-digit ANI code, if required (in this case it is not neces-
sary to push [PTT]—transmit is automatic after entry of the
3rd digit).
• The transceiver transmits the pre-programmed selective code.
➃ When the transceiver rings (an answer back is received),
wait for a connection code from the connected station;
when the transceiver doesn’t ring, push [PTT] again to exit
the standby condition, then try again from step
➂ after wait-
ing awhile.
➄ When the connection code is received, a beep sounds,
then “” flashes; when the connection code is not re-
ceived within 10 sec., the transceiver transmits a discon-
nect code automatically (“” does not flash). Try again
from step
➂ after waiting awhile , in such a case.
➅ When “” flashes, you can converse with the connected
station.
• Push to transmit; release to receive.
➆ When your conversation is finished, transmit the discon-
nect code.
• While pushing [PTT], push [#].
• Some transceivers cannot transmit a disconnect code depend-
ing on programming.
NOTE: When your conversation extends into the ANI time-
out time, the transceiver transmits a disconnect code au-
tomatically.
To Next Page
Loading...
