■ Scan types
D Scan resume condition
When a signal is received dur-
ing scanning, the scan resume
condition determines what ac-
tion the transceiver takes. The
IC-T2H has 2 scan resume
conditions available as illus-
trated at right. Use initial set
mode to select the one which
best suits your needs.
➀ While pushing [8] + [0], turn power on to enter initial set
mode.
➁ Push [t] one or more times until
“SC” appears.
➂ Push [Y]/[Z] to select the desired
scan resume condition.
• Pause scan: when receiving a signal,
scan pauses on the signal until it dis-
appears, then resumes.
Timer scan: when receiving a signal,
scan pauses on the signal for 10 sec.,
then resumes.
➃ Turn power off, then on again to exit initial set mode.
USING
INITIAL SET MODE
To Next Page
Loading...
