19
6
MEMORY/CALL PROGRAMMING
■ General
The transceiver has 40 memory channels (plus 1 pair of scan
edge channels and 1 call channel) for storage of often-used
frequencies. In addition, the USA version has 10 marine
weather channels (however, these are not programmable).
D Memory/call channel contents
The following information can be programmed into mem-
ory/call channels:
• Operating frequency
• Duplex direction (DUP or –DUP) with an offset frequency
(pgs. 15, 16)
• Subaudible tone encoder or tone squelch on/off (pgs. 15,
26)
• Subaudible tone and tone squelch frequencies (pgs. 15, 26)
• Skip information* (p. 25)
*Except for scan edge memory channels.
■ Programming a memory
channel
➀ Push [A V] to select VFO mode, if
necessary.
➁ Push 6 digit keys to enter the desired frequency.
➂ Push [DUP], [C T], etc. to set other
information as desired.
➃ Push [B M], then select a memory
channel number with [
Y]/[Z].
➄ Push [B M] for 1 sec. to program
the information into the channel
and return to VFO.
To Next Page
Loading...
