23
7
DTMF MEMORY
■ DTMF
transmission speed
When slow DTMF transmission speeds are required (as for
some repeaters), the transceiver’s rate of DTMF transmission
can be adjusted.
➀ While pushing [8] + [0], turn power on to enter initial set
mode.
➁ Push [t] one or more times until
“dt” appears.
➂ Push [Y]/[Z] to select the desired
DTMF transmission speed.
• Four speeds are available: “100” (100
msec. intervals) is the fastest; “500”
(500 msec. intervals) is the slowest.
➃ Turn power off, then on again to
exit initial set mode.
To Next Page
Loading...
