Icom IC-T2H - Cloning

36
12
CLONING
Cloning allows you to quickly and easily transfer the pro-
grammed contents from one transceiver to another trans-
ceiver; or, data from a PC to a transceiver using the optional
CS-T2
CLONING SOFTWARE .
D Transceiver-to-transceiver
cloning
➀ Connect the OPC-474 CLONING CABLE with adapter plugs
to the [SP] jack of the master and slave transceivers.
• The master transceiver is used to send data to the slave trans-
ceiver.
➁ While pushing [H/L] + [Y], turn power on to enter cloning
mode (master transceiver only—power on only for slave
transceiver).
•“CLonE” appears and the transceivers
enter the clone standby condition.
➂ Push [PTT] on the master trans-
ceiver.
•“CLoUT” appears in the master trans-
ceiver’s display and the S/RF indica-
tor shows that data is being
transferred to the slave transceiver.
•“CL In” appears automatically in the
slave transceiver’s display and the
S/RF indicator shows that data is
being received from the master trans-
ceiver.
AT
POWER ON
➃ When cloning is finished, turn power off, then on again to
exit cloning mode.
D Cloning using a PC
Data can be cloned to and from a PC (IBM compatible) using
the optional CS-T2
CLONING SOFTWARE and the optional OPC-
478
CLONING CABLE . The software is necessary to access the
IC-T2H’s ANI mode. Consult the CS-T2
CLONING SOFTWARE
HELP message for details.
D Cloning error
NOTE: DO NOT push the [PTT] on the slave transceiver
during cloning. This will cause a cloning error.
When the display at right appears, a
cloning error has occurred.
In such a case, both transceivers au-
tomatically return to clone standby condition and cloning must
be repeated.
IC-T2H Manual 01.12.5 4:31 PM Page 36 (1,1)