69
9 DATA OPERATION
New2001
DD
Setting from the RC-24
qPush [MODE] to select DD (Data) mode.
•“DD” appears.
wSet the desired frequency.
ePush [RP•4] several times to select “RPS,” when connect-
ing the PC through repeater/s.
• “RPS” displayed briefly.
rPush [CS••1] to enter call sign select mode, then rotate
[DIAL] to select the desired station call sign.
• Refer to the pages 42 to 44 for call sign setting when the desired
call sign is not programmed.
For direct data transferring between ID-1s, go to step
ii
.
tPush [CS••1] one more time to select “RPT1,” then ro-
tate [DIAL] to select the desired near-by repeater call sign,
if desired.
• Refer to the pages 42 to 44 for call sign setting when the desired
call sign is not programmed.
yPush [CS••1] one more time to select “RPT2,” then ro-
tate [DIAL] to select the gateway repeater call sign, if de-
sired.
uPush [ ] for 0.5 sec. to enable the gateway connection,
when the repeater require the “G” setting.
•“G” appears beside the call sign.
NOTE: When the near-by repeater is gateway repeater,
push [ ] for 0.5 sec. (if necessary) after the call sign set-
ting into “RPT1” in step t and skip step y.
iPush [CS••1] once (or twice) to exit call sign select
mode.
oPush [TXinh• ] to release transmission inhibit.
•“RPS” appears instead of “TXinh” indication.
• Starts accessing to the desired PC (via repeater/s).
!0Open “Network Computers.”
• The shared folder of the desired station appears.
• It may takes a minutes until the shared folder appears according
to the conditions, or PC performance.
!1Open the shared folder, then drag and drop the desired file
to transferring.
!2Push [TXinh• ] again to disconnect (inhibit the trans-
mission) from the gateway repeater.
ID-1_ENG_2.qxd 04.9.22 9:29 Page 69 (1,1)
To Next Page
Loading...
Need help?
General
