Icom ID-1

76
10
MEMORY/CALL OPERATION
New2001
10
• Call Sign— YOUR, RPT1, RPT2
Click to select the cell, then enter the desired station or
repeater call sign from the PC keyboard directly.
• SKIP
Double click then select the skip condition.
• Not selectable for the scan edges and call channels.
• Memory Name
Click to select the cell, then enter the desired memory
name from the PC keyboard directly.
tRepeat the steps w to r to program another memory or
call channels.
yTo close the Memory Channel screen, click “” in tool bar
or click “
.
”
DD
Programming with the RC-24
qSet the desired frequency in VFO mode.
➥ Set the operating mode with [MODE].
➥ Set the frequency using [DIAL] or keypad.
➥ Set other data (e.g. station call sign, tone information,
etc.), if required.
wPush [MW•6] momentarily.
• The previously selected memory channel number blinks.
eRotate [DIAL] to select the desired memory/call channel to
be programmed.
• Push [V/M] to select the previously selected memory channel
(the same memory channel as displayed at step w), push [CALL]
to select call channel 1.
• Select “MC1” as the call channel 1, “MC2” as the call channel 2
and “MC3” as the call channel 3.
rPush [MW•6] for 0.5 sec. to program.
• 3 beeps sound.
• Memory channel number automatically increases when continu-
ing to push [MW•6] after programming.
LOW
FM
M00
1294.500
[MW•6]
ID-1_ENG_2.qxd 04.9.22 9:30 Page 76 (1,1)