Icom ID-50A

34
1
7
4
10
15
18
2
8
13
5
11
16
3
9
14
6
12
17
BASIC MANUAL
9
MAINTENANCE
■ Resetting
Occasionally, erroneous information is displayed when, for example, rst applying power.
This may be caused externally by static electricity or by other factors.
If this problem occurs, perform a Partial reset or an All reset.
BE CAREFUL! An All reset clears all programming and returns all settings to the factory
defaults. See the Advanced manual for details.
After performing an All reset, you cannot use the DR function because the Repeater List
contents are also cleared.
D Partial Reset
[MENU] > SET > Others > Reset > Partial Reset
1. Push [MENU].
2. Select “Others” in the “SET” menu.
3. Select “Reset.”
4. Select “Partial Reset.”
• The conrmation dialog is displayed.
5. Select “YES.”
• “PARTIAL RESET” is displayed, and then the display automatically returns to the default
screen.
TIP: A Partial Reset resets the operating settings to their defaults without clearing the
following:
• Memory Channel contents • Message data • Repeater list
• Scan Edge contents • DTMF memory contents
• Call sign memories • Radio Memory contents
• Call Channel contents • GPS memory contents