D-STAR OPERATION
49
D-STAR GUIDE
■ Accessing repeaters
This section describes how to check whether or not you can access your local area
repeater (access repeater), and your signal is successfully sent to a destination repeater.
TIP: If your call sign (MY) has not been set, or your call sign and D-STAR equipment
have not been registered at a D-STAR repeater, see pages 43 ~ 46.
Step 1: Set “FROM” (Access repeater).
1. Push D-pad() to select “FROM,” and then push [ENT].
2. Select “Repeater List.”
3. Select the repeater group where your access repeater is listed.
4. Select your access repeater.
• Returns to the DR screen, and the selected repeater name is displayed in “FROM.”
By just selecting the repeater name, the repeater call sign, its frequency, duplex
setting, and frequency oset are automatically set.
A repeater list here is just an example.
Step 2: Set “TO” (Destination).
1. Push D-pad() to select “TO,” and then push [ENT].
2. Select “Gateway CQ.”
3. Select the repeater group where your destination repeater is listed.
4. Select your destination repeater.
• Returns to the DR screen, and the selected repeater name is displayed in “FROM.”
TIP: There are several ways to set your access repeater. (p. 61)
• Setting by [DIAL]
• Searching for a repeater using the DR scan
• Searching for the nearest repeater
• Setting from the TX History
To Next Page
Loading...
