Icom ID-50A

INTRODUCTION
42
D-STAR GUIDE
1
7
4
10
15
18
2
8
13
5
11
16
3
9
14
6
12
17
NOTE:
• Using the repeater list is required to use the DR function. (p. 64)
• Before operating in the Duplex mode, BE SURE to check whether the repeater is busy,
or not. If the repeater is busy, wait until it is clear, or ask for a ‛break’ using a method
acceptable to your local procedures.
• The transceiver has the Time-Out Timer function for the DV Repeater operation. The timer
limits a continuous transmission. Warning beeps will sound approximately 30 seconds
before timeout and then again immediately before the time-out.
Local Area call
Access
repeater
Area 1
repeater
Area 1
Area 1 Area 2
Gateway call
Simplex call
Area 1
repeater
Area 2
repeater