Icom ID-800H

9
1
DIGITAL MODE OPERATION
New2001
z Push [
SET B(D-OFF)] to enter call sign set mode.
• Push [
YY
] or [
ZZ
] to select “CALLS,” if necessary.
x Push [ SET B(D-OFF)] or [ ENT C(T-OFF)] several
times to select the call sign item, then push
[BAND].
•“RPT1 C” or “RPT2 C” appears for repeater call sign.
c Push [
YY
] or [
ZZ
] to select the desired call sign
channel.
•“r01” to “r54” appears.
v Push [BAND] for 1 sec. to enter call sign pro-
gramming mode.
• The 1st digit blinks.
b Push [
YY
] or [
ZZ
] to select the desired character
or code.
• Push [ SET B(D-OFF)] or [ ENT C(T-OFF)] to move the
cursor right or left respectively.
n Push [ SET B(D-OFF)] to select 2nd digit, then
push [
YY
] or [
ZZ
] to select the desired character or
code.
• The 2nd digit blinks (1st digit stops blinking).
• Repeat this step for programming other station call
signs.
m Push [BAND] for 1 sec. to save the call sign.
, Push [
YY
] or [
ZZ
] to select an another channel
from “r01” to “r54.”
. Repeat v to m to program another station call
sign channels.
⁄0 Push [
CLR A(MW)] to exit call sign set mode.
NOTE: During the call sign programming mode (v to n),
push [VFO/LOCK] to clear the entered call sign
(the cursor
returns to the 1st digit position), push [VFO/LOCK] again to
select the previously saved call sign.
SET
B
ID-800H_FirmupInfo.qxd 05.10.27 9:08 Page 9 (1,1)