Icom ID-800H

16
1 DIGITAL MODE OPERATION
New2001
■ Copying the call sign
DD
Copying the call sign memory contents
This function is convenient when saving additional notes for
areas
(for mobile operation) or unit number/initials (if several
transceivers are available), or modifying a part of the current call
sign.
q During VFO mode, push [SET•LOCK] to enter call sign set
mode.
• Rotate [DIAL] to select “CALL” if necessary.
w Push [SET•LOCK] or [S.MW•MW] several times to select
“MyCALL,” “UrCALL,” “RPT1 C” or “RPT2 C” as desired.
e Rotate [DIAL] to select the desired call sign channel to be
copied.
• M01 to M06, U01 to U99 and r01 to r54 are available.
r Push [SET•LOCK] for 1 sec. to set the selected call sign
for operation.
t Rotate [DIAL] to select the desired call sign channel to
copy to.
y Push [S.MW•MW] for 1 sec. to copy the selected call sign
into the selected call sign memory.
u Modify the copied call sign as described in “Call sign pro-
gramming”
(pgs. 1–4) or “Repeater call sign programming”
(pgs. 8, 9).
to select “r15”
Rotate
MDDE
Rotate
to select “r20”
MDDE
Push for 1 sec.
Push for 1 sec.
• Example— Copying the call sign memory “r15”
into “r20”
ID-800H_FirmupInfo.qxd 05.10.27 9:08 Page 16 (1,1)