Icom ID-800H

12
1 DIGITAL MODE OPERATION
New2001
DD
Repeater operation into another zone
qSet the desired repeater’s frequency, offset and shift direc-
tion in VFO mode.
(instruction manual; p. 21)
• Select “DV” mode in advance.
wSet your own call sign. (p. 5)
eSet the desired station call sign. (pgs. 6, 7)
• When making a CQ call
Set the desired repeater’s
(in a different zone) call sign, for
the area you want to make a CQ call, into “UrCALL.”
- “/,” stands for “CQCQCQ,” is added at the 1st digit automatically.
rSet the repeater’s call sign as follows;
a Push [SET•LOCK] to enter call sign set mode
• Rotate [DIAL] to select “CALL” if necessary.
s Push [SET•LOCK] or [S.MW•MW] several times to se-
lect “RPT1 C.”
d Rotate [DIAL] to select the nearest repeater’s call sign.
f Push [SET•LOCK] for 1 sec. to set the call sign for
“RPT1 C.”
g Push [SET•LOCK] to select “RPT2 C.”
h Rotate [DIAL] to select the gateway repeater’s
(in the
same zone) call sign.
• The call sign should have “G” setting as the 8th digit.
j Push [SET•LOCK] for 1 sec. to set the call sign for
“RPT2 C.”
k Push one of [TONE•T-SCAN•BK], [LOW•DUP] or
[MONI•DTMF•EMR] to exit call sign set mode.
tPush [PTT] to transmit; release to receive.
z Set the desired repeater’s frequency, offset and
shift direction in VFO mode.
(instruction manual;
p. 21)
• Select “DV” mode in advance.
x Set your own call sign. (p. 5)
c Set the desired station call sign. (pgs. 6, 7)
• When making a CQ call
Set the desired repeater’s
(in a different zone)
call
sign, for the area you want to make a CQ call,
into “UrCALL.”
v Set the repeater’s call sign as follows;
a
Push [ SET B(D-OFF)] to enter call sign set mode.
• Push [
YY
] or [
ZZ
] to select “CALL” if necessary.
s Push [ SET B(D-OFF)] or [ ENT C(T-OFF)] several
times to select “RPT1 C.”
d Push [
YY
] or [
ZZ
] to select the nearest re-
peater’s call sign.
f Push [
SET B(D-OFF)] for 1 sec. to set the call
sign for “RPT1 C.”
g Push [
SET
B(D-OFF)] to select “RPT2 C.”
h Push [
YY
] or [
ZZ
] to select the gateway re-
peater’s
(in the same zone) call sign.
• The call sign should have “G” setting as the 8th digit.
j Push [ SET B(D-OFF)] for 1 sec. to set the call
sign for “RPT2 C.”
k Push [
CLR A(MW)] to exit call sign set mode.
b Push [PTT] to transmit; release to receive.
SET
B
ID-800H_FirmupInfo.qxd 05.10.27 9:08 Page 12 (1,1)