Icom ID-800H

15
1
DIGITAL MODE OPERATION
New2001
DD
Received station call sign indication
➥ Push and hold [TONE•T-SCAN•BK], until 2 beeps sound,
to display the received station call sign.
• The first 6-digit of the stored call sign in “RXCALL” are displayed.
• While continuing to hold [TONE•T-SCAN•BK] even if 2 beeps
sound, a long beep will sound and the stored call signs (in “RX-
CALL,” “RXRPT1” and “RXRPT2”) are set for operation (see
“One-touch reply using the call record” as below). While continu-
ing to hold [TONE•T-SCAN•BK] even if a long beep sounds, a
long beep will sound again and the break-in function will be set
(see p. 22)
DD
One-touch reply using the call record
The stored call signs in the call record can be set for opera-
tion to reply to the call.
q After receiving a call, push and hold [TONE•T-SCAN•BK]
until 2 regular and 1 long beeps sound.
Or, during the received call sign indication as described in
“Desired call sign indication” at left, push [SET•LOCK] for
1 sec.
• Set your own call sign (MyCALL) in advance.
• The call sign stored in “RXCALL” is set to “UrCALL,” “RXRPT1”
is set to “RPT2 C” and “RXRPT2” is set to “RPT1 C.”
w Push [PTT] to transmit; release to receive.
For your information
When the call that is specifying your own call sign is received,
the station and the using repeater call signs being used can
be set for operation automatically.
• When “Auto Received Call sign Write (RCW)” (instruction
manual; p. 87)
is set to ON, the stored station call sign in “RX-
CALL” is set to “UrCALL” automatically.
• When “Auto Received Repeater Call sign Write (RRW)”
(in-
struction manual; p. 88)
is set to ON, the stored station call
sign in “RXRPT1” is set to “RPT2 C” and “RXRPT2” is set
to “RPT1 C” automatically.
Important!
The set call signs with the “One-touch reply using the call
record” operation as at below left are for temporary opera-
tion only. Therefore, the set call signs will be erased when
another call sign is set.
• Never saved into a call sign memory.
If you want to save the set call signs, see “Copying the set
call sign contents for temporary operation”
(p. 17) for details.
ID-800H_FirmupInfo.qxd 05.10.27 9:08 Page 15 (1,1)