Icom ID-800H

20
1 DIGITAL MODE OPERATION
New2001
DD
Message Transmission
Select the message transmission function ON and OFF.
When ON is selected, the transceiver transmits a text mes-
sage (pre-programmed). (default: OFF)
q Set the operating frequency, call signs and other settings,
such as repeater, as desired.
w Push [SET•LOCK] to enter message set mode.
• Rotate [DIAL] to select “MESSAG,” if “CALLS” or “SET” is dis-
played.
e Push [SET•LOCK] or [S.MW•MW] several times until
“TXM-C” appears.
r Rotate [DIAL] to select the desired message channel.
•“C1” to “C6” available.
• See pgs. 18 and 19 for message programming.
t Push [S.MW•MW] to select the message transmission set-
ting, then rotate [DIAL] to select “TXM-ON.”
y Push [M/CALL•PRIO], [TONE•T-SCAN•BK], [LOW•DUP]
or [MONI•DTMF•EMR] to exit message set mode.
u Push [PTT] to transmit and send the selected message si-
multaneously.
z Set the operating frequency, call signs and other
settings, such as repeater, as desired.
x Push [
SET B (D-OFF)] to enter message set
mode.
• Push [
YY
] or [
ZZ
] to select “MESSAG” if necessary.
c Push [ SET B(D-OFF)] or [ ENT C (T-OFF)] several
times until “TXM-C” appears.
v Push [
YY
] or [
ZZ
] to select the desired message
channel.
b Push [
ENT C(T-OFF)] then [
YY
] to select “TXM-
ON.”
n Push [
CLR A(MW)] to exit message set mode.
m Push [PTT] to transmit and send the selected
message simultaneously.
SET
B
ID-800H_FirmupInfo.qxd 05.10.27 9:08 Page 20 (1,1)