Icom ID-800H

18
1 DIGITAL MODE OPERATION
New2001
■ Message items
DD
TX message programming
TX messages are available for up to 6 channels and each
channel can be programmed with a message of up to 20
characters. Available characters are 0 to 9, A to Z
(capital let-
ters only), some symbols and space.
A TX message channel C1 must be programmed, if you want
to use the GPS message. The GPS message is transmitted
from channel C1 only.
q Push [SET•LOCK] to enter message set mode.
• Rotate [DIAL] to select “MESSAG,” if “CALLS” or “SET” is dis-
played.
w Push [SET•LOCK] or [S.MW•MW] several times until
“TXM-C” appears.
e Push [BAND•MODE] then rotate [DIAL] to select the mes-
sage channel.
• One of either “C1” to “C6” blinks.
r Push [BAND•MODE] for 1 sec. to enter message pro-
gramming mode.
• The 1st digit blinks and the channel indication stops blinking.
t Rotate [DIAL] to select the desired character.
• Push [SET•LOCK] or [S.MW•MW] to move the cursor right or
left, respectively.
y Push [SET•LOCK] to select 2nd digit, then rotate [DIAL] to
select the desired character.
• 2nd digit blinks (1st digit stops blinking).
• Repeat this step for programming.
u Push [BAND•MODE] for 1 sec. to save the message.
i Repeat steps w to u to set other message channels.
o Push [M/CALL•PRIO], [TONE•T-SCAN•BK], [LOW•DUP]
or [MONI•DTMF•EMR] to exit the message set mode.
ID-800H_FirmupInfo.qxd 05.10.27 9:08 Page 18 (1,1)