Icom ID-800H

21
1
DIGITAL MODE OPERATION
New2001
DD
RX message indication
When a call with a message is received, the message can be
stored into the RX message record.
The message is cleared once turning power OFF, or over-
written when another message is received.
q When the call with a message is received, the digital mes-
sage indicator blinks.
w Push [SET•LOCK] to enter message set mode.
• Rotate [DIAL] to select “MESSAG,” if necessary.
e Push [SET•LOCK] or [S.MW•MW] several times until “RX-
MSG” or “RX-CAL” appears.
• When “RX-CAL” is displayed, rotate [DIAL] to select “RX-MSG.”
• When “RX-CAL” is selected, the station call sign, that the mes-
sage is send, is displayed at the next step.
Push [SET•LOCK] or [S.MW•MW] to display last 6-digit or first
6-digit of the call sign, respectively, in this case.
r Push [BAND•MODE] to display the message, then push
[SET•LOCK] or [S.MW•MW] several times to scroll the
message.
t Push [M/CALL•PRIO], [TONE•T-SCAN•BK], [LOW•DUP]
or [MONI•DTMF•EMR] to exit the message set mode.
z When the call with a message is received, the
digital message indicator blinks.
x Push [
SET B (D-OFF)] to enter message set
mode.
• Push [
YY
] or [
ZZ
] to select “MESSAG” if necessary.
c Push [ SET B(D-OFF)] or [ ENT C (T-OFF)] several
times to select “RX-MSG” or “RX-CAL.”
• When “RX-CAL” is displayed, push [
YY
] or [
ZZ
] to se-
lect “RX-MSG,”
v Push [BAND] to display the message.
b Push [
SET B(D-OFF)] or [ ENT C (T-OFF)] to scroll
the message.
n Push [
CLR
A(MW)] to exit the message set mode.
For your information
When “Auto RX message Display (RMD)”
(instruction manual;
p. 89) is set to ON, the received message will be displayed
and scrolls automatically.
SET
B
Scroll indicator appears
ID-800H_FirmupInfo.qxd 05.10.27 9:08 Page 21 (1,1)