Icom ID-800H Firmware Update

2
1
New2001
DIGITAL MODE OPERATION
z Push [ SET B(D-OFF)] to enter call sign set mode.
• Push [
YY
] or [
ZZ
] to select “CALLS,” if necessary.
x Push [ SET B(D-OFF)] or [ ENT C(T-OFF)] several
times to select “MyCALL,” then push [BAND].
c Push [
YY
] or [
ZZ
] to select the desired call sign
channel.
v Push [BAND] for 1 sec. to enter call sign pro-
gramming mode.
• The 1st digit blinks.
b Push [
YY
] or [
ZZ
] to select the desired character or
code.
• Push [ SET B(D-OFF)] or [ ENT C(T-OFF)] to move the
cursor to right or left respectively.
n Push [ SET B(D-OFF)] to select 2nd digit, then push
[
YY
] or [
ZZ
] to select the desired character or code.
• The 2nd digit blinks (1st digit stops blinking).
• Repeat this step for programming your own call sign.
m Push [BAND] for 1 sec. to save the call sign and
enter the note programming mode.
• Up to a 4-digit of note (operating radio type or area)
can be set.
, Push [BAND] for 1 sec. to save the note and exit
the note programming mode.
. Push [
YY
] or [
ZZ
] to select an another channel
from “M01” to “M06.”
⁄0 Repeat c to , to program other call sign chan-
nels.
⁄1 Push [
CLR A(MW)] to exit call sign set mode.
NOTE: During the call sign programming mode
(v to m),
push [VFO/LOCK] to clear the entered call sign
(the cursor
returns to the 1st digit position), push [VFO/LOCK] again to
display the previously saved call sign.
SET
B
ID-800H_FirmupInfo.qxd 05.10.27 9:08 Page 2 (1,1)

Icom ID-800H Specifications

General

Brand	Icom
Model	ID-800H
Category	Transceiver
Language	English