Icom ID-800H

86
11
DIGITAL MODE OPERATION
11
r Push [BAND•MODE] to display the message, then push
[SET•LOCK] or [S.MW•MW] several times to scroll the
message.
t Push [M/CALL•PRIO], [TONE•T-SCAN•BK], [LOW•DUP]
or [MONI•DTMF•EMR] to exit the message set mode.
z When the call with a message is received, the
digital message indicator blinks.
x Push [
SET B (D-OFF)] to enter message set
mode.
• Push [
YY
] or [
ZZ
] to select “MESSAG” if necessary.
c Push [ SET B(D-OFF)] or [ ENT C (T-OFF)] several
times to select “RX-MSG” or “RX-CAL.”
• When “RX-CAL” is displayed, push [
YY
] or [
ZZ
] to se-
lect “RX-MSG,”
v Push [BAND] to display the message.
b Push [
SET B(D-OFF)] or [ ENT C (T-OFF)] to scroll
the message.
n Push [
CLR A(MW)] to exit the message set mode.
For your information
When “Auto RX message Display (RMD)”
(p. 101) is set to
ON, the received message will be displayed and scrolls auto-
matically.
■ Break-in communication
The break-in function allows you to break into an another sta-
tion’s communications in both digital voice and low-speed
data operation.
q While receiving an another station’s communication, push
and hold [TONE•T-SCAN•BK] until 2 regular and 2 long
beeps sound to turn the break-in setting ON.
•“BK” appears.
• When a call sign has not been received correctly, “NoCALL” is
displayed and “BK” won’t be appears. Receive the call sign in-
cluded in a communicating signal again, or set the call sign man-
ually in this case.
wWhen both stations are in standby, transmit to send a
break-in call.
• Programmed call sign station receives the break-in call as well
as your call sign.
eWait for the reply call from the station who receives the
break-in call.
rAfter receiving the reply call, communicate normally.
tTo cancel the break-in, push and hold [TONE•T-SCAN•BK]
for 1 sec. to turn OFF.
SET
B
Scroll indicator appears
ID-800H_1.qxd 2007.06.14 3:09 PM Page 86